Dakota Quad Cab 4WD V6-3.9L VIN X (2001)
Fig. 55 Throttle Cable At Throttle
a. Operate throttle body lever (by hand) to full open throttle position. Slip cable end rearward from pin on throttle lever (Fig. 55).
Fig.56 Cable Release Tab - Typical
b. Remove cable housing at throttle body mounting bracket by pressing forward on release tab with a small screwdriver (Fig. 56). To prevent
cable housing breakage, press on tab only enough to release cable from bracket. Lift cable housing straight up from bracket while pressing on
release tab. Remove cable housing.
6. Remove cable from vehicle.
INSTALLATION
CAUTION: Be careful not to damage or kink cable core wire (within cable sheathing) while servicing accelerator pedal or cables.
1. On these Engines:
a. Snap cable end onto lever pin (Fig. 55).
b. Connect cable to throttle body mounting bracket (push down and lock).
2. Install remaining cable housing end into dash panel opening (snaps into position).
