Dakota Quad Cab 4WD V6-3.9L VIN X (2001)
3.
Disconnect the pump motor connector (Fig. 2).
4.
Remove screws attaching CAB to the Hydraulic control Unit (HCU) (Fig. 3).
5.
Remove the CAB.
6.
Place the new CAB onto the HCU (see Parts Required section).
NOTE:
ENSURE THE CAB SEAL IS IN POSITION BEFORE INSTALLATION.
7.
Install the mounting screws and tighten to 4-4.7 N.m (36-42 in. lbs.).
8.
Connect the pump motor harness.
9.
Connect the harnesses to the CAB and lock the connectors.
10.
Connect battery.
NOTE:
THE NEW CAB MUST HAVE THE TIRE SIZE AND AXLE TYPE PROGRAMMED INTO THE NEW CONTROLLER IN ORDER TO HAVE
THE CONTROLLER COMMUNICATE THE PROPER VEHICLE SPEED. FAILURE TO PROPERLY PROGRAM THE REPLACEMENT CAB
WILL RESULT IN A BLINKING ABS INDICATOR.
11.
Inspect rear tires to determine tire sizes.
