Dakota Quad Cab 4WD V6-3.9L VIN X (2001)
17. Remove rear bearing from pinion (Fig. 52) with Puller/Press C-293-PA and Adapters C-293-47.
18. Remove depth shims from the pinion shaft and record shim thickness.
INSTALLATION
NOTE: The ring gear and pinion are serviced in a matched set. Do not replace the pinion without replacing the ring gear. If ring and pinion gears or
bearings are replaced, Refer to Differential; Adjustments for Pinion Gear Depth Setting.
1. Apply Mopar Door Ease or stick lubricant to outside surface of bearing cup.
2. Install rear pinion bearing cup (Fig. 53) with Installer C-4308 and Driver Handle C-4171 and verify cup is seated.
3. Apply- Mopar Door Ease or stick lubricant to outside surface of bearing cup.
