Dakota Quad Cab 4WD V6-3.9L VIN X (2001)
2. Install new pinion seal with Installer C-4076-B and Handle C-4735-1 (Fig. 22)
3. Install companion flange on the end of the shaft with the reference marks aligned.
4. Install bolts into two of the threaded holes in the companion flange 180° apart.
5. Position Holder 6719 against the companion flange and install a bolt and washer into one of the remaining threaded holes. Tighten the bolts so
Holder 6719 is held to the flange.
6. Install companion flange on pinion shaft with Installer C-3718 and Holder 6719.
7. Install the pinion washer and a new pinion nut. The convex side of the washer must face outward.
CAUTION: Do not exceed the minimum tightening torque when installing the companion flange retaining nut at this point. Damage to
collapsible spacer or bearings may result.
8. Hold companion flange with Holder 6719 and tighten the pinion nut to 285 Nm (210 ft. lbs.)(10 ft. lbs.) (Fig. 23). Rotate pinion several
revolutions to ensure the bearing rollers are seated.
