Dakota R/T 2WD V8-5.9L VIN Z (1998)
7.
Peel the door inner belt weather strip seal from the door (Figure 4 and Figure 5).
8.
Roll each window down and up several times again. If the squeak is still heard, further diagnosis is required. If the squeak is gone, perform the
Repair Procedure.
PARTS REQUIRED:
AR (2) 55255888AD
Seal, Front Door Glass Belt Inner Weather Strip, Dakota
AR (2) 55256706AD
Seal, Front Door Glass Belt Inner Weather Strip, Durango
AR (2) 55256868AD
Seal, Rear Door Glass Belt Inner Weather Strip
REPAIR PROCEDURE:
THIS REPAIR IS COMPATIBLE WITH DAIMLERCHRYSLER'S MOBILE SERVICE PROGRAM AND NOT REQUIRE HOISTS OR OTHER
FULL SERVICE FACILITY SPECIAL EQUIPMENT.
1.
With the inner belt weatherstrip already removed, slide the new weather strip seal (see Parts Required section) into position onto the door.
2.
Align the trim panel hooks with the receptacles on the inner door panel and slide the trim panel into place.
3.
Secure the trim panel to the door with the screws.
4.
If equipped, install the window crank.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
23-51-17-96
Weatherstrip, Door Window Belt
Replace, Front Door, One Side
0.3 Hrs.
