Dakota R/T 2WD V8-5.9L VIN Z (1998)
CAUTION: When installing the serpentine accessory drive belt, the belt must be routed correctly. If not, engine may overheat due to water pump
rotating in wrong direction. The correct belt with correct length must be used.
a) Install generator. Tighten bolts to 41 Nm (30 ft. lbs.).
b) Install support bracket (generator mounting bracket-to-intake manifold). Tighten bolts to 54 Nm (40 ft. lbs.) torque.
c) Position drive belt over all pulleys except idler pulley (located between generator and A/C compressor).
