Dakota R/T 2WD V8-5.9L VIN Z (1998)
Exhaust Pipe: Service and Repair
Extension Pipe Replacement
CAUTION: When servicing or replacing exhaust system components, disconnect the oxygen sensor connector(s). Allowing the exhaust to hang by
the oxygen sensor wires will damage the harness and/or sensor.
REMOVAL
1. Raise and support the vehicle.
2. Saturate the clamp nuts with heat valve lubricant. Allow 5 minutes for penetration.
3. Remove the front and rear clamp nuts or.
4. It may be necessary to loosen other sections of the exhaust system to remove the extension pipe.
INSTALLATION
1. Position the extension pipe in the muffler or and the catalytic converter flange.
2. If other sections of the exhaust system where loosened in removal, refer to the section for tightening procedures.
3. Install the clamps and nuts. Tighten the nuts to 47 Nm (35 ft. lbs.) torque.
4. Lower the vehicle.
5. Start the engine and inspect for exhaust leaks and exhaust system contact with the body panels. Adjust the alignment, if needed.
