Dakota R/T 2WD V8-5.9L VIN Z LDC (1999)
Power Seat Motor: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the driver side seat, adjuster and motors assembly from the vehicle as a unit.
3. Unplug the power seat wire harness connectors at each of the three power seat motors.
4. Release the power seat wire harness retainers from the seat adjuster and motors assembly.
5. Remove the four screws that secure the power seat adjuster and motors assembly to the seat cushion frame.
6. If the vehicle is equipped with a split bench seat, remove the fasteners that secure the center seat cushion section to the brackets on the power seat
adjuster.
7. Remove the power seat adjuster and motors assembly from the seat cushion frame.
CAUTION: Before installing the seat into the vehicle, be certain to adjust the seat fully rearward on its tracks. Then install and tighten the front
track mounting screws before installing the rear screws or the tracks may be damaged.
8. Reverse the removal procedures to install.