Dakota R/T 2WD V8-5.9L VIN Z LDC (1999)
Brake Light Switch: Service and Repair
The content of this article reflects the changes called out by TSB 26-05-99.
REMOVAL
Stop Lamp Switch & Bracket
1. Disconnect switch harness.
2. Press and hold brake pedal in applied position.
3. Rotate switch counterclockwise about 30° to align switch lock tab with notch in bracket.
4. Pull switch rearward out of mounting bracket and release brake pedal.
INSTALLATION
1. Press and hold brake pedal down.
2. Install switch. Align tab on switch with notch in switch bracket. Then insert switch in bracket and turn it clockwise about 30° to lock it in place.
3. Connect harness wires to switch.
4. Release brake pedal.
5. Move the release lever on the switch to engage the switch plunger. The switch is now adjusted and can not be adjusted again.
