Dakota R/T 2WD V8-5.9L VIN Z LDC (1999)
Turn Signal Flasher: Service and Repair
WARNING: ON VEHICLES EQUIPPED WITH AIR-BAGS, REFER TO AIRBAGS BEFORE ATTEMPTING ANY STEERING WHEEL,
STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER
PRECAUTIONS COULD RESULT IN ACCIDENTAL AIR-BAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the fuse access panel by unsnapping it from the driver side end of the instrument panel.
3. Refer to Junction Block Diagrams for combination flasher identification and location.
Combination Flasher Remove/Install
4. Remove the combination flasher from the junction block.
INSTALLATION
1. Refer to Junction Block Diagrams for proper combination flasher location.
2. Position the combination flasher in the proper receptacle in the junction block.
3. Align the combination flasher terminals with the terminal cavities in the junction block receptacle.
4. Push in firmly on the combination flasher until the terminals are fully seated in the terminal cavities in the junction block receptacle.
5. Install the fuse access panel by snapping it into the driver side end of the instrument panel.
6. Reconnect the battery negative cable.
