Dakota R/T 2WD V8-5.9L VIN Z LDC (1999)
Removing Pull Tab
6. Raise pull tab until it separates from quick-connect fitting. Discard old pull tab.
7. Disconnect quick-connect fitting from fuel system component being serviced.
8. Inspect quick-connect fitting body and fuel system component for damage. Replace as necessary.
9. Prior to connecting quick-connect fitting to component being serviced, check condition of fitting and component. Clean parts with a lint-free cloth.
Lubricate with clean engine oil.
10. Insert quick-connect fitting into fuel tube or fuel system component until built-on stop on fuel tube or component rests against back of fitting.
11. Obtain a new pull tab. Push new tab down until it locks into place in quick-connect fitting.
12. Verify a locked condition by firmly pulling on fuel tube and fitting (15-30 lbs.).
13. Connect negative cable to battery.
14. Start engine and check for leaks.
Typical Two-Tab Type Quick Connect Fitting
TWO-TAB TYPE FITTING
This type of fitting is equipped with tabs located on both sides of the fitting. These tabs are supplied for disconnecting the quick-connect fitting from
component being serviced.
CAUTION: The interior components (O-rings, spacers) of this type of quick-connect fitting are not serviced separately, but new plastic retainers are
available. Do not attempt to repair damaged fittings or fuel lines/tubes. If repair is necessary, replace the complete fuel tube assembly.
WARNING: THE FUEL SYSTEM IS UNDER A CONSTANT PRESSURE (EVEN WITH THE ENGINE OFF). BEFORE SERVICING
ANY FUEL SYSTEM HOSES, FITTINGS OR LINES, THE FUEL SYSTEM PRESSURE MUST BE RELEASED. REFER TO THE FUEL
PRESSURE RELEASE PROCEDURE.
Disconnection/Connection
1. Perform fuel pressure release procedure. Refer to Fuel Pressure Release Procedure.
2. Disconnect negative battery cable from battery.
3. Clean fitting of any foreign material before disassembly.
4. To disconnect quick-connect fitting, squeeze plastic retainer tabs against sides of quick- connect fitting with your fingers. Tool use is not required
