Dakota R/T 2WD V8-5.9L VIN Z LDC (1999)
Latch Clip Removal
LATCH CLIP FITTING (FUEL LINE-TO-FUEL RAIL)
A tethered latch clip is used to secure the fuel line to the fuel rail. A special tool will be necessary to separate fuel line from fuel rail after latch clip is
removed. This same latch clip may also be used to secure other different fuel system components.
CAUTION: The interior components (O-rings, spacers, retainers) of this type of quick-connect fitting are not serviced separately. Do not attempt to
repair damaged fittings or fuel lines/tubes. If repair is necessary, replace the complete fuel tube assembly.
WARNING: THE FUEL SYSTEM IS UNDER A CONSTANT PRESSURE (EVEN WITH THE ENGINE OFF). BEFORE SERVICING
ANY FUEL SYSTEM HOSES, FITTINGS OR LINES, THE FUEL SYSTEM PRESSURE MUST BE RELEASED. REFER TO THE FUEL
SYSTEM PRESSURE RELEASE PROCEDURE.
Disconnection/Connection
1. Perform fuel pressure release procedure. Refer to Fuel Pressure Release Procedure.
2. Disconnect negative battery cable from battery.
3. Clean fitting of any foreign material before disassembly.
4. Pry up on latch clip with a screwdriver.
5. Slide latch clip toward fuel rail while lifting with screwdriver.
Fuel Line Disconnection
6. Insert special fuel line removal tool (Snap-On number FIH 9055-1 or equivalent) into fuel line. Use this tool to release locking fingers in end of
line.
7. With special tool still inserted, pull fuel line from fuel rail.
8. After disconnection, locking fingers will remain within quick-connect fitting at end of fuel line.
9. Prior to connecting fuel line to fuel rail, check condition of both fittings. Clean parts with a lint-free cloth. Lubricate with clean engine oil.
10. Insert fuel line onto fuel rail until a click is felt.
11. Install latch clip (snaps into position). If latch clip will not fit, this indicates fuel line is not properly installed to fuel rail. Recheck fuel line
connection.
12. Verify a locked condition by firmly pulling on fuel line and fitting (15-30 lbs.).
