Dakota R/T 2WD V8-5.9L VIN Z LDC (1999)
3.
Select # 1 MDS DIAGNOSTICS OR DRB UPDATE on the DRB III(R).
4.
Use the arrow keys and select DIAGNOSTIC MENU on the MDS, then press NEXT MENU.
5.
Use the arrow keys and select VEHICLE CONTROLLER PROGRAMMING on the MDS, then press NEXT MENU.
6.
Use the arrow keys and select PROGRAMMING OF ALL OTHER CONTROLLERS USING MDS & DRB III(R) on the MDS, then press NEXT
MENU.
7.
Follow the steps presented on the MDS and DRB III(R) which will allow the DRB III(R) to obtain the current part number of the PCM.
8.
The MDS will display the part number of the PCM on the vehicle and the appropriate replacement part number, then press NEXT MENU to begin
programming.
If the PCM on the vehicle has already been updated or programmed, a NO UPDATES AVAILABLE message will be displayed. Check the part
number of the PCM on the vehicle and compare it to the part number displayed. If the PCM has already been updated, then another condition
exists that will require further diagnosis and repair.
9.
The MDS and DRB III(R) will prompt for any operator action needed during the remainder of the programming process.
NOTE:
XJ VEHICLES EQUIPPED WITH AN AISIN WARNER TRANSMISSION MAY SET DTC $BE (CCD MESSAGE FROM JTEC FAILURE)
WITHIN THE TCM BECAUSE OF THE FLASH PROCEDURE AND THE DTC LOGGED IN THE TCM MAY SET DTC $89 (TCM
CONTROLLER DTC PRESENT) WITHIN THE PCM. CHECK FOR AND ERASE THESE DTC'S PRIOR TO RETURNING THE VEHICLE TO
THE CUSTOMER.
NOTE:
THE FOLLOWING STEPS ARE REQUIRED BY LAW.
10.
Type the necessary information on the "Authorized Software Update Label" p/n 04669020 (Figure 1). Attach the label to the PCM and cover the
label with the clear plastic overlay.
11.
Type the necessary information on the "Authorized Modification Label" p/n 04275086 and attach the label near the VECI Label (Figure 2).
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
08-19-42-92
0.5 Hrs.
