Dakota R/T 2WD V8-5.9L VIN Z LDC (1999)
Electronic Brake Control Module: Service and Repair
Rear Wheel Antilock Brake System
NOTE: If the Controller Antilock Brakes (CAB) needs to be replaced, the rear axle type and tire revolutions per mile must be programmed into the
new CAB.
REMOVAL
RWAL Controller
1. Push the CAB harness connector lock to release the lock and remove the connector from the controller.
2. Remove the RWAL valve harness connector from the controller.
3. Remove the controller mounting screws and remove the controller from the mounting bracket.
INSTALLATION
1. Position the controller on the bracket.
2. Install the mounting screws and tighten to 6 Nm (53 inch lbs.).
3. Install the RWAL valve harness connector into the controller.
4. Install the CAB harness connector into the controller and push down on the connector lock.