Daytona L4-135 2.2L SOHC (1984)
Fig. 4 Removing caliper
REMOVAL
1. Remove brake fluid until reservoir is half full.
2. Raise and support front of vehicle, then remove wheel and tire assembly.
3. Remove caliper guide pin and anti-rattle clips.
4. Remove caliper from disc by sliding caliper assembly out and away from braking disc. Suspend caliper with wire so as not to damage flexible
brake hose.
5. Remove outboard brake lining, then lift off rotor and remove inboard brake lining.
Fig. 4 Caliper piston installation
INSTALLATION
1. Push piston back into cylinder bore with uniform pressure until it is bottomed.
2. Position inboard shoe and lining on adapter, then install rotor.
3. While holding outboard shoe in position on adapter, carefully position caliper over disc brake rotor.
4. Lower caliper over rotor and adapter.
5. Install guide pin through bushing, caliper and adapter.
6. Press in on guide pin and thread pin into adapter. Torque pin to 25 to 40 ft. lbs. on 1982 - 83 models and 25 to 35 ft. lbs. on 1984 - 87 models.
7. Install wheel and tire assembly, then lower vehicle.
