Daytona L4-135 2.2L SOHC (1984)
Brake Caliper: Service and Repair
ATE Dual Pin Floating Caliper Disc Brake (Front)
Fig. 8 Disassembled view of disc brake caliper. All front wheel drive exc. 1982---84 Omni & Horizon; 1983---84 Charger & Turismo
DISASSEMBLE
1. Remove caliper assembly as described under Brake Shoe & Lining, Replace.
2. With brake hose attached to caliper. carefully depress brake pedal to push piston out of caliper bore. Prop brake pedal to any position below first
inch of brake pedal travel to prevent brake fluid loss.
3. If pistons are to be removed from both calipers, disconnect brake hose at frame bracket after removing piston, then cap brake line and repeat
procedure to remove piston from other caliper.
4. Disconnect brake hose from caliper.
5. Mount caliper in a soft jawed vise.
6. Support caliper and remove dust boot and discard.
7. Using a small wooden or plastic stick, remove seal from groove in piston bore and discard.
8. Using a suitable tool, remove bushings from caliper.
Installing New Piston Seal In Caliper
