Daytona L4-135 2.2L SOHC Turbo (1985)
FIGURE 3 - Noise Suppression Module
3.
"H" Body
a.
Remove one screw on side of navigator (Figure 3).
b.
Install male end of Suppression Module, PN 4374075, into navigator.
c.
Using original navigator screw (discard supplied screws), align suppression module with hole and install screw (Figure 3).
d.
With soldering iron (using rosin core solder), position other end of suppression module bracket as indicated in Figure 3 and solder in place.
e.
Install navigator body wiring harness into female connector of suppression module.
4.
Reinstall navigator per service manual procedures.