Daytona L4-135 2.2L SOHC Turbo (1985)
Front Door Window Motor: Service and Repair
REMOVAL
Power Window Regulator Flex Track To Drive Arm
1.
Raise or the lower the window until the screw that attaches the flex track to the drive arm is in alignment with the access hole.
2.
Remove the flex track attaching screw from the drive arm.
3.
Manually move the window to the "full up" position and secure with a block under the window glass.
Flex Drive Window Regulator
4.
Remove the regulator attaching rivets by center punching the rivet and drilling the heads off with a 1/4 inch drill bit.
5.
Maneuver the motor end of the regulator through the access hole and rotate the regulator assembly out completely.
6.
Remove the screws that attach the motor to the regulator and remove the motor from the regulator track.
INSTALLATION
1.
Install the window motor to the regulator track and check for proper gear mesh with the flex track. Secure with original screws.
2.
Insert the top of the regulator track through access hole in the door. Rotate the regulator until the window motor aligns with the access hole and
insert the regulator completely into the door.
3.
Fasten the regulator to the inner door panel with new rivets in the order shown.
4.
Plug in the wiring harness to the window motor.
5.
Actuate the window motor until the flex track screw hole is visable in the access hole.
6.
Lower the window manually until the drive arm is aligned with the flex track screw hole.
7.
Install the flex track to drive arm attaching screw.
