Daytona V6-181 2972cc 3.0L SOHC VIN 3 FI (1992)
Combination Switch: Service and Repair
Dual Function Switch Replacement
Dual-function Switch
Disable airbag, refer to Supplemental Restraint Systems/Air Bags / Service and Repair. . After procedure has been completed, rearm airbag
system.
On these models, the dual-function switch contains circuits for hazard warning switching and turn signal cancellation. The switch is mounted on the
lefthand side of the steering column.
REMOVAL
1. Disconnect battery ground cable.
2. On models with tilt column, remove tilt lever.
3. On all models, remove upper and lower steering column covers.
4. Remove tamper proof screws attaching switch to steering column.
5. Carefully pull switch away from column. Release connector lock on wiring connector, remove connector from switch, then remove the switch.
INSTALLATION
1. Install wiring connector to switch. Ensure switch locking tab is fully seated in wiring connector.
2. Mount switch on column and torque attaching screws to 17 in lbs.
3. Install upper and lower steering column covers and torque attaching screws to 17 in lbs.
4. On models with tilt column, install tilt lever.
5. On all models, connect battery ground cable.
6. Check all functions of switch for proper operation.