dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Throttle Body|Service and Repair > < Throttle Body - Intermittent Power Loss|Page 3045
Page 1
background image

Throttle Body: Testing and Inspection

Minimum Air Flow Air Metering Fitting

Minimum Air Flow Connections

Warning:  Apply parking brake and/or block wheels before performing any engine running test with the vehicle on the ground.

Note:  Before performing minimum air flow test, make sure all accessories are off.

1. With vehicle in PARK (A/T) or NEUTRAL (M/T), START the engine and allow it to warm up until the cooling fan cycles ON and OFF at least

once, then shut OFF the engine.

2. Connect a timing light and tachometer to the engine.
3. Disconnect the coolant temperature sensor and START the engine. Adjust basic timing to 12° BTDC +/- 2°, then shut OFF the engine and connect

the coolant temperature sensor.

4. Disconnect the PCV valve hose from the PCV valve and plug the PCV valve nipple.
5. Disconnect the idle purge hose from the engine vacuum harness tee and install a 0.125" orifice tube (Miller Tool# 6457 or equivalent) in the intake

manifold mounted idle purge hose.

6. Connect the scan tool to the engine compartment diagnostic connector. START the engine and allow it to idle for at least one minute.
7. Using the scan tool, access the Minimum Airflow Idle Speed Test. When this mode is entered, the following will occur:

a. Idle Air Control (IAC) motor will fully close.
b. Idle spark advance will become fixed.
c. The engine rpm will be displayed on the scan tool.

8. Check the idle rpm with a tachometer. If the idle rpm is not within the range below. Clean throttle body and retest. SEE Fuel Delivery and Air

Induction/ Component Service and Repair.

9. Shut OFF the engine; remove the scan tool, tachometer, timing light, and orifice tube; and connect the purge line and PCV valve to their respective

ports.

10. Erase any fault codes that may have been set.  

Note:  If vehicle passes minimum airflow test, and still exhibits idle speed problems, perform Idle Air Control (IAC) motor actuation test using scan tool.

Odometer Reading                

Idle Speed

Less than 1000 miles                

625-950 RPM

More than 1000 miles                

750-950 RPM

Throttle Body|Service and Repair > < Throttle Body - Intermittent Power Loss|Page 3045