Daytona V6-181 2972cc 3.0L SOHC VIN 3 FI (1992)
2.
Connect the DRB-II to the Flash Programming Adapter.
3.
Connect the Flash Programming Adapter to the Engine 6-Way Cable.
4.
Connect the Engine 6-Way Cable to the Engine Diagnostic Connector.
5.
Connect the Engine 6-Way Cable Red Battery Clip to the Positive Terminal of the Vehicle Battery.
6.
Turn the vehicle ignition on.
7.
The DRB-II Will Power Up and Prompt Through the Sequence of Windows as Shown.
8.
When the Update is Complete, Turn the Vehicle Ignition Off.
NOTE:
IF AN ERROR HAPPENS, WRITE DOWN THE ERROR MESSAGE (OFF THE SCAN TOOL SCREEN). THEN PRESS MODE AND THE ATM
KEYS TOGETHER ON THE SCAN TOOL TO RETRY (REBOOT).
THE UNDERHOOD TEMPERATURE DURING PROGRAMMING MUST BE BETWEEN -40 DEGREES F (-40 DEGREES C) AND +185
DEGREES F (+85 DEGREES C).
9.
IMPORTANT:
THIS STEP IS REQUIRED BY LAW. Type the necessary information on the "Authorized Software Update Label" and attach to the PCM.
