Daytona V6-181 2972cc 3.0L SOHC VIN 3 FI (1992)
Distributor Cap Inspection
Light scaling of the terminals can be cleaned with a sharp knife. If the terminals are heavily scaled, replace the distributor cap.
A cap that is greasy, dirty or has a powder-like substance on the inside should be cleaned with a solution of warm water and a mild detergent.
Scrub the cap with a soft brush. Thoroughly rinse the cap and dry it with a clean soft cloth.
Installation
1. Install rotor and tighten screw.
1. Install cap and tighten hold down screws.
2. Remove one spark plug wire at a time from the old cap and install on the correct tower of the new cap.
3. Make sure all plug wires are seated securely in cap towers.