Daytona V6-181 2972cc 3.0L SOHC VIN 3 FI (1992)
Headlight Switch: Service and Repair
Disable airbag, refer to Air Bags/Service and Repair. After procedure has been completed, rearm airbag system.
1. Disconnect battery ground cable.
2. Remove switch pod assembly. Refer to Instrument Panel, Gauges and Warning Indicators/Instrument Panel/Service and Repair.
3. Remove turn signal lever by pulling straight out of pod.
4. Remove five pod inner panel attaching screws, then the inner panel.
5. Remove turn signal switch to gain access to headlight switch. Refer to Turn Signal Switch.
6. Disconnect headlight switch linkage from buttons.
7. Remove switch mounting screws, then the switch.
8. Reverse procedure to install, noting the following:
a. Latch switch linkage in up position.
b. Insert dimmer shaft into dimmer knob while aligning switch in switch pod.
c. Unlatch linkage and connect to push buttons.
d. Check all switch modes for proper operation.
