Daytona V6-181 3.0L SOHC VIN 3 FI (1993)
Trim Panel: Service and Repair
Interior Mouldings, Panels And Trim Covers
DOOR OPENING SCUFF PLATES
1. Open front door.
2. Remove screws holding scuff plate to door sill.
3. Separate scuff plate from vehicle.
4. Reverse the preceding operation for installation.
A-PILLAR AND ROOF RAIL MOULDINGS
1. Open front door.
2. Remove push-in fasteners holding A-pillar moulding to roof rail above door opening.
3. Remove trim plug and screw holding A-pillar molding to A-pillar
4. Slide A-pillar moulding upward and pull rearward to separate moulding from A-pillar.
5. Reverse the preceding operation for installation.
LOWER QUARTER TRIM PANEL
1. Remove tail panel trim cover and security shade if equipped
2. Remove rear seat cushion and backs.
3. Remove seat back latch striker bezel.
4. Remove screw covers. Remove screws holding lower quarter trim panel to quarter.
5. Pull rearward end of trim panel away from quarter panel and push trim forward to clear door opening flange.
6. Separate lower quarter trim panel from vehicle.
7. Reverse the preceding operation for installation.
UPPER QUARTER TRIM PANEL
1. Remove lower quarter trim panel.
2. Remove rear seat shoulder harness turning loop cover.
3. Remove bolt holding belt turning loop to C-pillar.
4. Remove bolt holding font seat belt to floor at door sill.
5. Remove screw holding coat hook to roof rail.
6. Remove roof rail moulding as necessary to clear quarter panel removal path.
7. Remove push-in fastener holding upper quarter trim to front rail.
8. Remove screw covers from trim panel to gain access to screws.
9. Remove screws holding upper quarter trim to quarter panel.
10. Raise and support lift gate in the up position. Disconnect bottom of lift cylinder.
11. Swing rear of trim panel away from quarter panel and pull trim forward to clear door opening flange.
12. Separate upper quarter trim panel from vehicle.
