Daytona V6-181 3.0L SOHC VIN 3 FI (1993)
3. Lube fuel pressure regulator O-ring with clean engine oil, and install fuel pressure regulator onto fuel rail. Install mounting bolts and torque to 8.7
Nm (77 in-lbs). Install fuel pressure regulator hoses and clamps and torque to 1 Nm (10 in-lbs).
4. Connect fuel injector wiring harness to engine wiring harness, and connect vacuum harness to fuel rail assembly. Remove covering from intake
manifold, and clean surface.
5. Place intake manifold gaskets on lower manifold, with beaded sealer up. Install intake plenum and torque fasteners to 13 Nm (115 in-lbs).
6. Connect fuel inlet line to fuel rail and torque clamp to 1 Nm (10 in-lbs). Connect vacuum harness to air intake plenum and fuel pressure regulator.
Connect coolant temperature sensor electrical connector to sensor.
7. Connect brake booster supply hose to intake plenum and connect PCV hose to plenum. Connect IAC motor and TPS, and connect vacuum vapor
harness to throttle body.
8. Install throttle cable, and air inlet hose assembly. Connect negative battery cable.
NOTE: ASD and fuel pump relays remain energized for 7 minutes during the following test, unless the test is stopped or the ignition switch is
turned to the OFF position.
9. Using scan tool, place ignition switch in "RUN" position and use Actuate Output Test "Auto Shutdown (ASD) Relay", to activate fuel pump and
pressurize system.
10. Check for leaks.
