Daytona IROC V6-181 3.0L SOHC VIN 3 FI (1992)
Fuel Door Release Cable: Service and Repair
Cable Release Handle And Cable
REMOVAL
1. Move driver s seat forward to expose rear of seat adjuster.
2. Remove nuts used to fasten the adjuster to the floor pan.
3. Move driver's seat to the rear.
4. Remove the bolts used to fasten the adjuster to the floor pan.
5. Remove the driver's seat.
6. Open the liftgate.
7. Remove two screws, a "Christmas Tree" fastener, and the remote release handle cover.
8. Open the fuel filler door.
9. Remove the remote handle retaining screws and lift the remote handle assembly upward.
10. Remove the rear seat.
11. Remove the rear seat latch cover.
12. Remove the lower quarter trim panel from each side.
13. Remove the upper quarter trim panel from each side.
14. Remove the lower liftgate trim panel.
15. Remove screws used to fasten the rear window washer bottle to the inner quarter panel.
16. Disconnect the wiring harness from the rear window washer motor.
17. Disconnect the filler neck from the rear window washer bottle.
18. Remove the rear window washer bottle.
19. Remove the fuel filler door remote release cable nut from inside of the fuel filler door opening.
20. Cut both ends from the old fuel filler door cable using a pair of side cutters.
INSTALLATION
1. The original cables used to operate both fuel filler door and liftgate are clamped to each other and inseparable. For fear of damaging a cable still in
good working condition, do not attempt to separate and remove any cable. Place the replacement cable over the original.
2. Connect the cable to the remote handle assembly.
3. Install the remote handle assembly.
4. Install the other end of the cable through the hole provided on the inside of the fuel filler door opening.
5. Install the cable retaining nut.
6. Close the fuel filler door and try the system for proper operation.
7. Starting at the rear of the vehicle, tape the new cable to the old one using duct tape.
8. Place the rear window washer bottle into the opening provided.
9. Connect the filler neck to the washer bottle.
10. Connect the wiring harness to the washer motor.
11. Install the window washer bottle retaining screws.
12. Install the quarter trim panels and the lower liftgate trim panel.
13. Install the rear seat latch cover and the rear seat.
14. Install the remote release handle cover.
15. Install the driver's seat.
