Daytona IROC R/T L4-135 2213cc 2.2L DOHC Turbo VIN A FI (1993)
Fuel Injector Ports
BEFORE INSTALLING FUEL RAIL
1.
Seat all injectors in receiver cups and install lock rings.
2.
Clean injector ports if necessary.
3.
Connect injector wiring connectors and secure with wire clips.
4.
Lube injector O-rings with clean 30 weight motor oil.
INSTALLATION
NOTE: Make sure oil separator bracket is on top of fuel rail bracket.
1.
Install injectors in ports and install mounting bolts, tighten bolts evenly, making sure all injectors are not binding as they enter ports.
2.
Once all injectors are seated, tighten mounting bolts to 200 in-lbs (22.5 Nm).
3.
Connect vacuum hose to pressure regulator.
4.
Connect injector harness to the main engine harness.
5.
Lubricate chassis fuel tube ends with clean engine oil and connect hoses to tubes, (pull back to make sure they are securely attached).
NOTE: ASD and fuel pump relays remain energized for 7 minutes during the following test, unless the test is stopped or the ignition switch is
turned to the OFF position.
6.
Using scan tool, place ignition switch in "RUN" position and use Actuate Output Test "Auto Shutdown (ASD) Relay", to activate fuel pump and
pressurize system.
7.
Check for leaks.
