Daytona Pacifica L4-135 2.2L SOHC Turbo VIN E FI (1988)
Evaporator Core: Service and Repair
Manual Air Conditioning
1. Disconnect battery ground cable, then discharge refrigerant from A/C system and disconnect lines from evaporator heater assembly.
2. Drain cooling system, then disconnect and plug heater hoses from evaporator heater assembly.
3. Remove A/C condensate drain and disconnect vacuum lines.
4. On Daytona and LeBaron models with passive restraint system, remove outer steering column cover.
5. On Daytona and LeBaron models with passive restraint system, remove hood release and parking brake release handles from inner steering column
cover, then remove the cover.
6. On all models, slide front bench seat or right front bucket seat back as far as possible.
7. On all models, remove right cowl side trim.
8. On all models, remove glove box. If necessary, remove right instrument panel reinforcement to allow glove box removal.
9. On Daytona and LeBaron models, proceed as follows:
a.
Remove forward console bezel, side trim and lower carpet panels.
b.
Loosen floor console and move rearward, then remove forward console.
c.
On models with passive restraint system, remove instrument panel-to-floor reinforcement.
10.
On all models, remove center distribution and defroster adapter ducts.
11.
On all models, disconnect blower motor electrical connector, then the demister hoses from top of evaporator heater assembly.
12.
On models less automatic temperature control, proceed as follows:
a.
Disconnect temperature control cable flag from bottom of evaporator heater assembly.
b.
Unfasten cable from left side of heat distribution duct.
c.
Disconnect vacuum lines from evaporator heater assembly.
13.
On all models, unfasten antenna cable from clip on evaporator heater assembly.
14.
On all models except Dynasty, Lancer, LeBaron GTS and New Yorker, fold carpet back from right side of floor.
15.
On all models, remove four evaporator heater assembly attaching nuts from engine compartment side.
16.
Remove lower screw from hanger strap, then rotate the strap aside.
17.
Pull evaporator heater assembly rearward until mounting studs are cleared, then lower unit.
18.
On all models except Acclaim, Shadow, Spirit and Sundance, pull lower right side of instrument panel rearward and rotate assembly while pulling
from under instrument panel.
19.
Place evaporator heater unit on bench, then remove evaporator heater unit top cover.
20.
Remove expansion valve seal and retaining screw from under sealing plate, then lift evaporator core out of assembly.
21.
Reverse procedure to install.
