Daytona Shelby V6-181 3.0L SOHC (1991)
L. Enter the number that matches the body type of the vehicle that is being diagnosed. The display will change to read as follows:
---SELECT MODULE--
1) BODY COMPUTER
2) ELEC CLUSTER
M. Press the down arrow three times to view more of the menu. The screen will change to read as follows:
---SELECT MODULE--
3) EVIC
4) ENGINE NODE
5) TRAVELER
N. Press the down arrow three more times to view more of the menu. The screen will display:
---SELECT MODULE--
6) COMPASS/TEMP
7) ELE/MECH CLUST
8) COMPASS/MINI TRP
0. Press the down arrow one more time to see the last menu item. The screen will change to read as follows:
---SELECT MODULE--
7) ELE/MECH CLUST
8) COMPASS/MINI TRP
9) SYSTEM TESTS
P. Enter the number that matches the module that is to be tested. The display will change to read as follows:
[name of module]
VERSION X.X
The name of the module that was selected will appear on the top line of the display. The version number of the module that is installed in the
vehicle will also appear on the display.
NOTE: The version number is subject to change. It may not appear on the display exactly as it is illustrated above.
After a few seconds, the display will change to read as follows, or press ENTER to change the display immediately
-MENU-
1) SYSTEM TESTS
2) READ FAULTS
NOTE: The menu will be named for the module that was selected. For example:
BODY COMP MENU
ENGINE NODE MENU
COMPASS/TEMP MENU
THEFT ALARM MENU
ELEC CLUST MENU
TRAVELER MENU
EVIC MENU
Q. Press the down arrow three times to view the rest of the menu. The screen will display:
--XXXXXXXX MENU--
3) STATE DISPLAY
4) ACTUATOR TESTS
5) ADJUSTMENTS
At this point, you have reached the module menu for the module you are testing. This menu lists the test categories that have been programmed
into the DRBII cartridge. From these categories, you can select any of the specific test functions of the DRBII diagnostic program.
Instructions for reading fault messages and for selecting DRBII test functions are found later in this HELP 1.
