Daytona Shelby V6-181 3.0L SOHC (1991)
To enter the vehicle theft alarm part of the DRBII program, select 7) THEFT ALARM. (Refer back to Step G.)
R. The display will change to read as follows:
BUS TEST IN PROGRESS
BUS OPERATIONAL
After a few seconds, the display will change to read as follows, or press ENTER to change the display immediately:
VEHICLE THEFT ALARM
VERSION X.X
NOTE: The version number is subject to change. It may not appear on the display exactly as it is illustrated above.
After a few seconds, the display again will change to read as follows, or press ENTER to change the display immediately:
--THEFT ALARM MENU--
1) SYSTEM FAULTS
2) READ FAULTS
S. Press the down arrow three times to view the rest of the menu. The screen will display:
-- THEFT ALARM MENU --
3) STATE DISPLAY
4) ACTUATOR TESTS
5) ADJUSTMENTS
At this point, you have reached the THEFT ALARM MENU of the THEFT ALARM diagnostic program. Now you can select any of the specific
test functions that have been programmed into the DRBII cartridge. Instructions for reading fault messages and for selecting DRBII test functions
are found below.
How to Read Fault Messages With the DRBII
To read fault message:
When the module menu screen is displayed, select 2) READ FAULTS.
-
If there are no fault messages, the display will read as follows:
xxxxxxx FAULTS
NO FAULTS
DETECTED
NOTE: xxxxxxx will be the name of the module,
-
If there are fault messages, the display will read as follows:
1 OF 3 FAULTS
[fault code & message appear here]
NOTE: The exact numbers displayed will vary depending on how many faults there are.
How to Select A DRBII Test Function
To perform a specific DRBII test function from one of the module menu test categories, proceed as follows.
A. Press the number of the desired test category, or move the arrows to the desired category and press ENTER. The display will change to a menu of the
test functions that are available in the selected category.
B. Press the number of the desired test function, or move the arrows to the desired function and press ENTER.
How to Use the DRBII Volt/Ohmmeter
To access the volt/ohmmeter function of the DRBII, proceed as follows.
