Daytona Shelby V6-181 3.0L SOHC (1991)
Connect the red volt/ohmmeter test lead to the red port at the right top of the DRBII.
NOTE: There are two ports at the top of the DRBII. Be sure to connect the lead to the correct port.
Voltmeter Mode
A. Press VOLT/OHM once. The top line of the display will change to read as follows:
B. Touch the test probe to the connector or wire to be measured.
C. Read the voltage on the DRBII display.
D. When voltage testing is done, press VOLT/OHM three times to exit voltmeter mode.
Ohmmeter Mode
A. Press VOLT/OHM twice The top line of the display will change to read as follows:
B. Touch the test probe to the connector or wire to be measured.
C. Read the resistance to ground on the DRBII display.
D. When resistance testing is done, press VOLT/OHM twice to exit ohmmeter mode.
NOTE: Some test steps require the use of an ohmmeter other than the DRBII ohmmeter. Before using an "external" ohmmeter, be sure it is
properly adjusted to take accurate readings of resistance. Refer to the manufacturer's operating instructions if necessary.
Continuity Meter Mode
A. Press VOLT/OHM three times. The top line of the display will change to read as follows:
*-NO CONTINUITY-*
B. Touch the test probe to the connector or wire to be measured.
C. Read the continuity on the DRBII display.
D. When continuity testing is done, press VOLT/OHM once to exit continuity meter mode.
How to Use the DRBII Menu
The DRBII screen reads as follows:
DRBII
1) VEHICLES TESTED
2) HOW TO USE
3) CONFIGURE
4) SELECT SYSTEM
VEHICLES TESTED - The display will read:
VEHICLES SUPPORTED:
1991 CHRYSLER
