Daytona Shelby V6-181 3.0L SOHC (1991)
Suspension Spring ( Coil / Leaf ): Service and Repair
Rear Coil Spring Replace
Fig. 2 Rear Axle & Suspension Assembly. Models Except Horizon & Omni
REMOVAL
1. Raise and support vehicle.
2. Support axle assembly and remove wheel and tire assemblies.
3. On models with air shocks, disconnect air lines. On all models, remove both upper and lower shock absorber attaching bolts, then the shock
absorbers.
4. On models equipped with automatic load leveling system, remove link from track bar to sensor.
5. On all models, lower axle assembly until spring and spring upper isolator can be removed.
INSTALLATION
1. Position jounce bumper to rail, install and torque attaching screws to 70 lb-in.
2. Install isolator over jounce bumper and install spring.
3. Raise axle and install shock absorbers. Loosely assemble lower shock absorber attaching bolts and torque upper attaching bolts to specifications.
On models with load leveling system, attach link to track bar.
4. With suspension supporting vehicle, torque shock absorber lower attaching screws to specifications.
