Daytona Shelby V6-181 3.0L SOHC (1991)
If you have any questions or need assistance in completing this action, please contact your Zone Service Office.
SAFETY RECALL -- TIRE PLACARD REPLACEMENT
Dear Chrysler Motors Vehicle Owner:
This notice is sent to you in accordance with the requirements of the National Traffic and Motor Vehicle Safety Act.
Chrysler Motors has determined that some 1991 model year Dodge Daytona ES and Shelby cars fail to conform to Federal Motor Vehicle Safety
Standard No. 110 -- Tire Selection and Rims.
This is due to installation of incorrect Tire/Pressure placards on the affected cars. These placards specify 14 inch tires as a recommended tire size,
instead of the proper 15 or 16 inch tires.
Your car, whose Vehicle Identification Number is shown on the enclosed form, is one of the affected vehicles. Therefore it requires installation of the
enclosed Tire/Pressure Placard to provide the correct tire size and pressure specifications as required by the Federal standard.
We ask that you apply the enclosed placard in place of the original placard, as described on the reverse side of this letter.
If preferred, you may schedule an appointment for installation by your dealer. This service will be provided free of charge, and should take about
one-half hour to complete. However, additional time may be required depending on how dealer service appointments are scheduled and processed. Take
the enclosed Owner Recall Notification Form and the placard with you at the time of your appointment and give them to your dealer. The form shows the
identification number for the vehicle which requires service.
If you have any problem obtaining the needed service, please contact the Chrysler Zone Service Office in your area. (It is listed under "Service
Assistance" in your Operator's Manual.) A Zone representative will arrange for prompt servicing of your car.
We regret any inconvenience which this action may cause you. However, we believe that you understand our concern for motor vehicle safety, and for
your continued satisfaction with our products. If your dealer falls or is unable to remedy this defect without charge within a reasonable time, you may
submit a written complaint to the Administrator, National Highway Traffic Safety Administration, 400 Seventh Street, S.W., Washington, D.C. 20590, or
call the Toll Free Auto Safety Hotline at 1-800-424-9393. (Washington D.C. area residents may call 366-0123.)
Thank you for your attention to this important matter.
TIRE/PRESSURE PLACARD REPLACEMENT INSTRUCTIONS
1.
Remove the existing placard from the location shown in the illustration by peeling it off, and discard it.
2.
Clean the now exposed surface by wiping with a household cleaner to remove any oil or grease. Adhesive left from removal of the original placard
