Diplomat V8-318 5.2L VIN 4 2-BBL (1983)
Propeller Shaft: Service and Repair
1. Remove both rear universal joint roller and bushing assembly clamps from pinion yoke. Do not disturb retaining strap holding roller assemblies on
cross.
2. Lower front of vehicle slightly to prevent loss of transmission oil and pull drive shaft out as an assembly.
3. To install, carefully slide yoke into splines on transmission output shaft.
4. Align rear of propeller shaft with pinion yoke and position roller and bushing assemblies into seats of pinion yoke.
5. Install bushing clamps and tighten clamp bolts to 170 inch lbs.
