Durango 2WD V6-3.7L (2009)
Canadian radio frequencies require transmitter signals to "time-out" (or quit) after several seconds of transmission which may not be long enough for the
HomeLink(R) transceiver to pick up the signal during programming. Similar to this Canadian law, some U.S. gate operators are designed to "time-out" in
the same manner.
If you live in Canada or you are having difficulties programming a gate operator by using the "Programming" procedures (regardless of where you live),
replace programming common homeLink(R) transceiver codes step 3 with the following:
NOTE: When programming a garage door opener or gate operator, it is advised to unplug the device or move the vehicle out of range during
the "cycling" process to prevent possible overheating.
-
3. Continue to press and hold the HomeLink(R) transceiver button while you press and release every two seconds ("cycle") your hand held
transmitter until the frequency signal has successfully been accepted. The EVIC will display "CHANNEL X TRAINING" and then "CHANNEL X
TRAINED". Proceed with "Programming" step 4 to complete.
