Durango 2WD V6-3.7L (2009)
12. Apply primer (1) around the perimeter of the glass to a width of 15 mm (0.5 in.) (2).
13. Allow primer to air dry for at least 10 minutes.
14. Using a flash light, verify that glass primer is without damage.
Glass Preparation - Installing A New Backlite
1. Apply four new spacers (1) to the liftgate frame and place them 55 mm in from the window opening; 70 mm from the upper edge and 150 mm
from the lower edge.
2. Install the lower spacers (2) to the backlite approximately 36 cm (1.0 in) from each side of the glass.
NOTE: Remove the lower spacers 2 hours after installation of the glass.
3. Position backlite in center of liftgate opening and resting on the side and lower spacers.
