Durango 2WD V6-3.7L (2009)
Trunk / Liftgate Hinge: Service and Repair
Hinge - Removal
REMOVAL
NOTE: It is not necessary to remove the liftgate to replace one or both hinges. The hinges can be replaced one at a time.
NOTE: A suitable body sealant should be used when removing or moving the hinges.
1. Support liftgate on a suitable lifting device.
2. Using a trim stick C-4755 or equivalent, remove the upper rear headliner trim.
3. Using a grease pencil or equivalent, mark the location of the hinge to aid installation.
4. Remove the liftgate bolts (2).
5. Remove the body bolts (1) and remove the hinge.
