Durango 2WD V6-3.7L (2009)
Trunk / Liftgate Motor: Service and Repair
Power Liftgate Link Rod - Installation
INSTALLATION
NOTE: In the event the liftgate ball stud becomes worn or damaged it may be replaced. Refer to the following procedure for ball stud
installation.
1. Position the ball stud (2) onto the liftgate (1) and install in mounting hole. Tighten ball stud to 28 Nm (20.5 ft. lbs.).
WARNING: Never attempt to operate the power liftgate system when the link rod is removed or disconnected. Damage to the power liftgate
system will result.
CAUTION: Make sure the retaining clips (1) are seated into the ball socket (2) fully when installed on the liftgate ball stud (3).