Durango 2WD V6-3.7L (2009)
Repair/Seat, Front/Seat - Removal
2. Remove the bolt (1) and separate the seat belt anchor (2).
3. Using a trim stick C-4755 or equivalent, separate the retaining clips and remove the upper rear header trim. See: Description and Operation/Rear
Header Panel - Description
4. Remove the screw (1).
5. Using a trim stick C-4755 or equivalent, separate the trim (2), retaining clips and anchor (3).
6. Remove the D-pillar trim (2) and pull the belt through the panel.
Installation
INSTALLATION
1. Position the seat belt through the hole in the D-pillar trim (2).
2. Position the D-pillar trim (2) in place on the D-pillar and anchor (3).
3. Seat the retaining clips fully and install the screw (1).
4. Position the rear header trim in place and seat the retaining clips fully.
