Durango 2WD V6-3.7L (2009)
2. Remove the appropriate seat cushion cover, See: Seat Cover/Service and Repair/Seat Cushion Cover - Removal.
3. Remove the rear center floor console, See: Interior Moulding / Trim/Console/Service and Repair/Rear Center Console - Removal.
4. Disconnect the inoperative heated second row seat cushion element electrical connector (2) and remove the harness routing clip from the console
bracket (1).
5. Remove the heater element by peeling it away from the foam cushion, being careful not to remove excessive foam in the process.
SEAT BACK ELEMENT
1. Disconnect and isolate the battery negative cable.
2. Remove the appropriate seat back trim cover (1), See: Seat Cover/Service and Repair/Seat Cushion Cover - Removal.
3. Remove the inner second row seat cushion (2) to seat back (1) bracket trim cover.
4. Disconnect the inoperative heated second row seat back element electrical connector (3) and remove the harness routing clip.
5. Remove the heater element by peeling it away from the foam cushion, being careful not to remove excessive foam in the process.
