Durango 2WD V6-3.7L (2009)
CAUTION: Dirt, oil, and solvents can damage caliper seals. Insure assembly area is clean and dry.
NOTE: Verify seal is fully seated and not twisted.
1. Lubricate caliper pistons, piston seals and piston bores with clean, fresh brake fluid.
2. Install new piston seals (3) into caliper bores (2).
3. Lightly lubricate lip of new boot with silicone grease. Install boot on piston and work boot lip into the groove at the top of piston (3).
4. Stretch boot (2) rearward to straighten boot folds, then move boot forward until folds snap into place.
5. Install piston (3) into caliper bore and press piston down to the bottom of the caliper bore by hand or with hammer handle.
6. Seat dust boot in caliper (2) with Handle C-4171 (1) and Installer (3):
-
54 mm caliper: Installer C-3716-A
7. Install the second piston and dust boot.
CAUTION: Use of alternative grease may cause damage to the boots seals.
8. Lubricate caliper mounting bolt bushings, boot seals and bores with Mopar brake grease or Dow Corning(R) 807 grease only.
9. Install the boot seals into the caliper seal bores and center the seals in the bores.
