Durango 2WD V6-3.7L (2009)
Auxiliary Water Pump: Service and Repair
Auxiliary HVAC Heater Pump - Installation
INSTALLATION
1. If required, install the retaining bracket (6) onto the auxiliary HVAC heater pump (1). Make sure the bracket is properly orientated the pump.
Tighten the bolt securely.
2. Position the auxiliary HVAC heater pump to the right frame rail (4) and install the two retaining bolts (5). Tighten the bolts to 8.5 Nm (75 in. lbs.).
3. Connect the heater hoses (2) to the auxiliary HVAC heater pump. Make sure the hose clamps (3) are securely engaged.
4. Connect the electrical connector (3) to the auxiliary HVAC heater pump (2).
5. If equipped, install the auxiliary HVAC heater pump splash shield.
6. Install the right front wheelhouse splash shield (1) See: Body and Frame/Fender/Front Fender/Front Fender Liner/Description and Operation.
7. Lower the vehicle.
8. Reconnect the 12 volt battery system.
9. Reconnect the high voltage battery system See: Starting and Charging/Battery/Service and Repair/Procedures.
10. Refill the engine cooling system See: Service and Repair.
