Durango 2WD V6-3.7L (2009)
Valve Cover: Service and Repair
Cylinder Head Cover(s) - Installation
INSTALLATION
CAUTION: Do not use harsh cleaners to clean the cylinder head covers. Severe damage to covers may occur.
NOTE: Left side shown, right side similar.
NOTE: The gasket may be used again, provided no cuts, tears, or deformation has occurred.
1. Clean the cylinder head cover and both sealing surfaces. Inspect and replace gasket as necessary.
2. Install the cylinder cover (2).
3. Tighten the cylinder head cover bolts and double ended studs (1) to 12 Nm (9 ft. lbs.).
4. Install the left side breather and connect breather tube.
5. Connect the fuel injector electrical connectors and injector harness retaining clips.
6. Install the resonator and air inlet hose.
7. Connect negative battery cable.