Durango 2WD V6-3.7L (2009)
Intake Manifold: Service and Repair
Intake Manifold - Removal
REMOVAL
1. Bleed the fuel system. See: Cylinder Head Assembly/Fuel Pressure Release/Service and Repair
2. Disconnect the negative cable from battery.
3. Remove the resonator assembly and air inlet hose.
4. Drain the cooling system below coolant temperature sensor level.
5. Disconnect the electronic throttle control (ETC) connector (3).
6. Disconnect electrical connectors for the following components:
-
Coolant Temperature Sensor
-
Manifold Absolute Pressure (MAP) Sensor (2)
