Durango 2WD V6-3.7L (2009)
2. Install the three screws (4) that secure the blend door actuator (2) to the top of the HVAC housing (3). Tighten the screws to 2 Nm (17 in. lbs.).
3. Connect the HVAC wire harness connector (1) to the blend door actuator.
4. Install the instrument panel assembly See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument
Panel - Installation.
5. Reconnect the negative battery cable.
6. Initiate the Actuator Calibration function using a scan tool See: Testing and Inspection/Component Tests and General Diagnostics/HVAC System
Test.
DUAL ZONE DRIVER SIDE
1. Position the blend door actuator (1) to the bottom of the HVAC housing (2). If necessary, rotate the actuator slightly to align the splines on the
actuator output shaft (3) with those on the blend-air door linkage (4).
