Durango 2WD V6-3.7L (2009)
1. On HEV models, disconnect the battery system using the service disconnect at the battery pack .
2. On gasoline only engine models, disconnect and isolate the negative battery cable.
3. Recover the refrigerant from the refrigerant system See: Service and Repair/Refrigerant System Recovery.
4. Remove the air cleaner housing and resonator (1) See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner
Housing/Service and Repair/Air Cleaner Body - Removal.
5. Remove the rear section of the A/C liquid line (2) from the plastic retainer (3) located on the right inner fender (4).
6. On HEV models, drain the coolant for the Traction Power Inverter Module (TPIM) (1) and remove the coolant recovery bottle .
7. Remove the TPIM and mounting bracket (2) to gain access to the A/C liquid line .
8. Remove the bolt (1) that secures the rear section of the A/C liquid line (2) to the receiver/drier (3).
9. Disconnect the rear section of the A/C liquid line from the receiver/drier and remove and discard the O-ring seal.
10. Install plugs in, or tape over the opened liquid line fitting and the receiver/drier port.
