Durango 2WD V6-3.7L (2009)
22. If necessary, remove the blower motor resistor or power module, depending on application or See: Control Module HVAC/Service and
Repair/Front Blower Motor Power Module - Removal.
23. Remove the HVAC wiring harness from the HVAC housing (3).
24. Remove the screws (4) that secure the two halves of the HVAC housing together.
25. Separate the two halves of the HVAC housing.
26. If necessary, remove the mode-air doors from the upper half of the HVAC housing.
27. Carefully lift the A/C evaporator (1) and insulator (3) out of the top of the HVAC housing (2).
NOTE: Front single zone system shown. Front dual zone system similar.
28. Remove the blend-air doors and linkage (1), mode-air door (2), baffle (3) and the duct plate (4) from the lower half of the HVAC housing (6).
29. If necessary, remove the floor distribution duct (5) from the HVAC housing See: Air Duct/Service and Repair/Floor Distribution Duct - Removal.
Rear HVAC Housing
DISASSEMBLY
NOTE: The rear heater-A/C housing must be removed from the vehicle for service of the blower motor and disassembled for service of the
A/C evaporator, heater core, mode-air door and blend-air door.
