Durango 2WD V6-3.7L (2009)
Refrigerant Pressure Sensor / Switch: Service and Repair
Front A/C Pressure Transducer - Removal
REMOVAL
NOTE: It is not necessary to discharge the refrigerant system to replace the A/C pressure transducer.
1. Disconnect and isolate the negative battery cable.
2. Disconnect the wire harness connector (1) from the A/C pressure transducer (2).
3. Remove the A/C pressure transducer from the A/C discharge line (3).
4. Remove the O-ring seal (4) from the discharge line fitting and discard.