Durango 2WD V6-3.7L (2009)
1. Disconnect and isolate the battery negative cable. On vehicles equipped with the optional Hybrid Electric Vehicle (HEV) system, a technician
trained in proper HEV service safety procedures must also remove the high voltage service disconnect from the high voltage battery pack.
2. Remove the center bezel (1) from the instrument panel. See: Dashboard / Instrument Panel/Service and Repair/Instrument Panel Bezel - Removal.
3. Use a small thin-bladed screwdriver to rotate the bulb holder (3) counterclockwise about 30 degrees to unlock it from the keyed opening in the
front A/C-heater control (2) circuit board.
4. Pull the bulb holder and bulb straight out of the circuit board.
Rear A/C-Heat Control
BULB - REAR A/C-HEAT CONTROL
1. Disconnect and isolate the battery negative cable. On vehicles equipped with the optional Hybrid Electric Vehicle (HEV) system, a technician
trained in proper HEV service safety procedures must also remove the high voltage service disconnect from the high voltage battery pack.
2. Remove the rear A/C-heater control from the center floor console. See: Heating and Air Conditioning/Control Assembly/Service and Repair/A/C
and Heater Control - Removal.
3. Use a small thin-bladed screwdriver to rotate the bulb holder (2) counterclockwise about 30 degrees to unlock it from the keyed opening in rear
A/C-heater control (1) circuit board.
4. Pull the bulb holder and bulb straight out of the circuit board.
