Durango 2WD V6-3.7L (2009)
Oil Change Reminder Lamp: Service and Repair
Evic Equipped Vehicles
Your vehicle is equipped with an engine oil change indicator system. The Oil Change Required message will flash in the EVIC display for
approximately 10 seconds after a single chime has sounded to indicate the next scheduled oil change interval. The engine oil change indicator system
is duty cycle based, which means the engine oil change interval may fluctuate dependent upon your personal driving style.
Unless reset, this message will continue to display each time you turn the ignition switch to the ON/RUN position. To turn off the message
temporarily, press and release the Menu button. To reset the oil change indicator system (after performing the scheduled maintenance) perform the
following procedure:
-
Turn the ignition switch to the ON position (Do not start the engine).
-
Fully depress the accelerator pedal slowly three times within 10 seconds.
-
Turn the ignition switch to the OFF/LOCK position.
NOTE: If the indicator message illuminates when you start the vehicle, the oil change indicator system did not reset. If necessary repeat this
procedure.
Non-Evic Equipped Vehicles
Your vehicle is equipped with an engine oil change indicator system. The Change Oil message will flash in the instrument cluster odometer for
approximately 12 seconds after a single chime has sounded to indicate the next scheduled oil change interval. The engine oil change indicator system
is duty cycle based, which means the engine oil change interval may fluctuate dependent upon your personal driving style.
Unless reset, this message will continue to display each time you turn the ignition switch to the ON/RUN position. To turn off the message
temporarily, press and release the Trip Odometer button on the instrument cluster. To reset the oil change indicator system (after performing the
scheduled maintenance) perform the following procedure:
-
Turn the ignition switch to the ON position (Do not start the engine).
-
Fully depress the accelerator pedal slowly three times within 10 seconds.
-
Turn the ignition switch to the OFF/LOCK position.
NOTE: If the indicator message illuminates when you start the vehicle, the oil change indicator system did not reset. If necessary repeat this
procedure.
